Power Sliding Back Window Sticking/Binding - Window Seal Bulletin
12.
Insert screw driver into lower channel and hit with mallet to separate lower channel from the window assembly (Figure 5).
13. Inspect the lower rail and motor assembly for damage or loose center glass, while cycling the motor, cable, glass, and lower rail assembly.
14.
If center glass is bonded to black carrier, proceed to Step 23, if not, proceed to Step 15.
15.
The preferred method is to re-bond the center glass to carrier, but center glass assembly is also available for service. Refer to Step 16 for
re-bonding or refer to Step 23 for replacing center glass assembly.
16.
Remove center glass from carrier and remove any remaining urethane.
