F 450 4WD Super Duty V10-6.8L VIN D (2004)
1.
Prior to window removal, verify that center glass is centered in the upper plastic channel (Figure 1). If center glass is not inside upper plastic
channel, pull channel down and out of upper aluminum channel and slide back in making sure the entire center glass is inside the plastic channel.
2.
If Step 1 resolves the issue, return the vehicle back to customer after verifying the window functions properly. If it did not resolve the issue,
proceed to Step 3.
3.
Open the rear window approximately half way.
4.
Refer to window removal procedure. (Refer to Workshop Manual (WSM), Section 501-11-24 and 501-11-25.)
5.
Remove cable clips from sheet metal. (Refer to WSM, Section 501-11-28.)
6.
Remove three (3) motor bracket attaching bolts. (Refer to WSM, Section 501-11-28.)
7.
Disconnect motor wiring harness from vehicle body harness. (Refer to WSM, Section 501-11-29.)
8.
Remove window assembly from vehicle window opening.
9.
Pull outer rubber seal from window frame (Figure 2).
