F 450 4WD Super Duty V10-6.8L VIN S (1999)
Parking Brake Cable: Adjustments
Motorhome Chassis
1. Raise and support the vehicle.
2. Disconnect the adjusting clevis.
1
Remove the clevis pin locking pin.
2
Remove the clevis pin, and disconnect the adjusting clevis from the parking brake lever.
3. Set the adjusting clevis.
1
Loosen the jam nut several turns.
2
Position the parking brake lever in the applied position.
3
Tighten or loosen the adjusting clevis until the adjusting clevis hole lines up with the parking brake lever hole, and then loosen the adjusting
clevis 13 mm (0.5 inch).
4. Install the pins, and tighten the jam nut.
1
Install the clevis pin through the adjusting clevis and the parking brake lever.
2
Install the locking pin in the clevis pin.
3
Tighten the jam nut.
5. Lower the vehicle.
6. Test the parking brake operation.
