F 450 4WD Super Duty V10-6.8L VIN S (1999)
7. NOTE: The wheel hub and bearing is a slip fit design and should not require a puller to remove it.
Remove the wheel hub and bearing.
1
Remove the four lock nuts.
2
Remove the wheel hub and bearing.
Installation
1. NOTE: Every time the wheel hub and bearing is removed for any reason, the O-ring seal must be replaced. Failure to do so can cause a vacuum
leak and loss of four wheel drive operations.
Replace the O-ring.
2. NOTE: Apply a coat of Ford High Temperature 4x4 Front Axle and Wheel Bearing Grease E8TZ-19590-A meeting Ford specification
ESA-M1C198 to the O-ring area of the wheel hub and bearing before installing the hub and bearing.
Install the wheel hub and bearing.
1
Position the wheel hub and bearing.
2
Install the four lock nuts.
3. NOTE: The following step applies only to vehicles equipped with ABS.
Connect the ABS sensor harness.
1
Position the ABS sensor harness and install the routing clips.
2
Connect the harness connector.
