F 450 4WD Super Duty V10-6.8L VIN S (1999)
2. NOTE: Use the yellow snap rings supplied in the universal kit. If difficulty is encountered installing the yellow snap rings, install the black snap
rings also supplied in the kit.
Remove the driveshaft from the tool and install the snap ring.
3. Repeat Steps 1 and 2 for the opposite side of the driveshaft yoke.
4. Install a new bearing cup.
1
Position a new bearing cup in the driveshaft slip yoke.
2
Install the driveshaft into the C-Frame and Screw.
3
Press the bearing cup just below the snap ring groove.
5. NOTE: Use the yellow snap rings supplied in the universal kit. If difficulty is encountered installing the yellow snap rings, install the black snap
rings also supplied in the kit.
Remove the driveshaft from the tool and install the snap ring.
6. Repeat Steps 4 and 5 for the opposite side.
