F 450 4WD Super Duty V10-6.8L VIN Z CNG (2003)
3. Disconnect the safety belt buckle warning indicator switch electrical connector and separate it from the mounting bracket.
4. Pull the wire harness and electrical connector through the seat.
INSTALLATION
All vehicles
1. To install, reverse the removal procedure.
NOTE: Make sure to tighten all nuts and bolts to specification.
2. Check the active restraint system for correct operation.
Supercab
Safety Belt Bolt Bit
SPECIAL TOOL(S)
REMOVAL
NOTE:
^
New safety belt buckles, height adjusters, center adjust tongues and belts and retractors can be installed separately. However, if a safety belt
assembly was in use during a collision, a new belt and retractor must be installed as well as the center adjust tongue and belt and buckle assembly,
or the center adjust tongue and the cable and buckle assembly. When installing new safety belts and buckles, height adjusters, safety cables and
buckles, center adjust tongues and belt and retractors, use only the parts specified in the Ford Master Parts Catalogs for the make and model of the
vehicle being repaired. Safety belt assemblies must not be interchanged between vehicle models.
^
Safety belt buckles are shown, safety belt and buckle is similar.
1. Remove the rear seat back.
