F 450 4WD Super Duty V10-6.8L VIN Z CNG (2003)
Power Steering Pump: Service and Repair
Power Steering Pump Pulley - CII Pump
Power Steering Pump Pulley - CII Pump
Special Tool(s)
Special Tool(s)
Removal
1. Remove the drive belt.
2. Using the special tool, remove the power steering pump pulley.
Installation
CAUTION: Replacement of the power steering pump pulley is necessary after being removed and installed two times.
1. Using the special tool, install the power steering pump pulley.
-
Inspect the pulley for paint marks in the web area near the hub. If there are two paint marks, discard the pulley. If there is no paint or one paint
mark, use a paint pencil to mark the web area of the pulley near the hub.
2. Install the drive belt.
