F 450 4WD Super Duty V10-6.8L VIN Z CNG (2003)
16. Rotate the valve housing with the holding fixture, and using the special tool, remove the bearing and power steering gear input shaft seal.
17. Remove the valve housing from the holding fixture.
18. Install the steering gear housing in the holding fixture. Using a suitable puller, remove the steering gear sector shaft dust seal from the sector shaft
seal bore.
19. Remove the spacer.
1
Remove the snap ring.
2
Remove the spacer.
20. NOTE: The steering gear sector shaft bearing is not replaceable.
Using the special tool, remove the sector shaft seal.
Assembly
