F 450 4WD Super Duty V8-6.0L DSL Turbo VIN P (2003)
Camshaft Position Sensor: Service and Repair
REMOVAL
1. Turn the ignition switch to the OFF position.
CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
2. Disconnect the Camshaft Position (CMP) sensor electrical connector.
NOTE: The CMP sensor is located behind the power steering pump.
3. Remove the bolt and the CMP sensor.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: Apply clean engine oil to the O-ring before installation.