F 450 4WD Super Duty V8-6.0L DSL Turbo VIN P (2003)
NOTE: Lightly lubricate the gasket with petroleum jelly to hold it in place during assembly.
Install the new extension housing gasket.
1
Verify that the extension has a shoulder cast in it.
2
Install the new extension housing gasket.
2. install the extension housing bolts.
3. Connect the Output Shaft Speed (OSS) sensor.
4. CAUTION: Be sure not to raise the back of the transmission too high. If it makes contact with the underbody, damage to the TSS and OSS
sensors will occur.
Install the rear transmission mount.
1
Raise the transmission up.
2
Install the rear transmission mount.
3
Install the bolts.
5. Lower the transmission on to the rear crossmember support.
