F 450 4WD Super Duty V8-6.0L DSL Turbo VIN P (2003)
7. Lower the rear of the transmission to gain access to the sensors.
8. Disconnect the electrical connector of the affected sensor.
9. CAUTION: Use care not to induce contamination in the form of dirt or foreign material when removing either of the sensors.
If necessary, remove the Turbine Shaft Speed (TSS) sensor.
1
Remove the bolt.
2
Remove the TSS.
10. Position the heated oxygen sensor (H02S) connector aside.
11. If necessary, remove the Output Shaft Speed (OSS) sensor.
1
Remove the bolt.
2
Remove the OSS.
Installation