F 450 4WD Super Duty V8-6.0L DSL Turbo VIN P (2003)
Special Tool(s)
Disassembly
1. CAUTION: Do not clamp the driveshaft in the jaws of a vice or a similar holding fixture.
Place the driveshaft on a suitable workbench.
2. Index-mark the double cardan yokes.
3. Remove all of the snap rings.
4. Clamp the special tool hi a swivel base vise.
5. CAUTION: Do not continue to tighten the special tool if the U-joint bottoms out in the yoke or damage will occur to the center bearing shield.
Using the special tool, press the two bearing cups out of the opposite side of the driveshaft center yoke.
^
Alternate the pressure between the U-joints.
