F 450 4WD Super Duty V8-6.0L DSL Turbo VIN P (2003)
All driveshafts
5. Install the driveshaft slip yoke.
1
Position the driveshaft slip yoke boot clamp.
2
Pull the driveshaft slip yoke boot toward the stub shaft tube.
3
Lubricate the stub shaft splines with grease.
4
Align the index marks, and install the driveshaft slip yoke.
5
Seat the driveshaft slip yoke boot in the boot groove.
Front driveshaft
6. Remove all excess grease from the slip yoke boot and the slip yoke.
7. Using the special too], install both driveshaft slip yoke boot clamps. Tighten the tool until the clamp is secure.
Rear driveshafts
8. Remove all excess grease from the slip yoke boot and the slip yoke.
9. Set the driveshaft assembled length to specification.
1
Set the driveshaft assembled length to specification.
^
Measure from the stub shaft weld to the U-joint centerline.
2
Bleed the air from the driveshaft slip yoke boot.
3
Position the driveshaft slip yoke boot clamp.
