F 450 4WD Super Duty V8-6.2L Flex Fuel (2011)
23. Using a suitable tool, hold the cage nut and remove the body mounting bolt.
-
Discard the bolt.
24. NOTICE: Do not use a standard nut as a replacement for the nut being removed. Failure to use the correct part number for the nut may
result in damage to the vehicle.
NOTE:
-
If the cage nut is not damaged, it is not necessary to replace it with a new cage nut. The old cage nut may be used if the threads of the nut are
not damaged.
-
Make sure that the surface of the cage nut retainer is flat prior to installing the cage nut.
-
Remove the new cage nut from the cage and install the cage nut into the pre-existing cage.
Install the new cage nut into the location that the damaged nut was removed from.
25. Bend the tabs of the cage nut retainer back into position to secure the cage nut.
26. Install a new body bolt.
-
To install, tighten the new bolt to 103 Nm (76 lb-ft).
Body Mount No. 3
27. Remove the rear seat, if equipped.
28. Position the carpet aside to gain access to the plug.
29. Using a suitable socket trace a 50 mm (1.968 in) outline around the access hole.
