F 450 4WD Super Duty V8-6.4L DSL Turbo (2008)
Throttle Body: Service and Repair
Throttle Body
THROTTLE BODY
Removal and Installation
1. Remove the air cleaner outlet pipe.
2. Loosen the clamp and disconnect the charge air cooler (CAC) tube.
-
To install, tighten to 12 Nm (106 lb-in).
3. Disconnect the throttle body (TB) electrical connector.
4. NOTE: Use a tool such as a Snap-On(R) FTXL30E, or equivalent, to access the bolts.
Remove the stud bolt, the bolts and the TB.
-
Remove and discard the press-in-place gasket.
-
To install, tighten to 10 Nm (89 lb-in).
5. To install, reverse the removal procedure.
-
Install a new press-in-place gasket.