F 450 4WD Super Duty V8-6.4L DSL Turbo (2008)
Slip-yoke installation
4. Inspect the driveshaft slip-yoke. Install a new yoke, if necessary.
5. Install the slip-yoke and new bearing cup.
1. Start a new bearing cup in the slip-yoke.
-
Check the needle bearings for correct positioning.
2. Position the slip-yoke on the spider.
3. Position the assembly in the C-Frame and Screw Installer/Remover.
4. Press the bearing cup to just below the snap ring groove.
6. Remove the shaft from the C-Frame and Screw Installer/Remover, and install the new snap ring.
Opposite bearing cup installation
7. Repeat Slip-yoke installation in this procedure to install the new bearing cup and snap ring on the opposite side of the driveshaft slip-yoke.
Final assembly
8. NOTE: Do not strike the bearings.
Check the U-joint for freedom of movement.
-
If binding, strike the yoke with a brass or plastic hammer.