F 450 4WD Super Duty V8-6.4L DSL Turbo (2008)
17. Install the snap ring.
18. Position the bearing cup on the spider trunion in the centering flange yoke.
19. Using the C-Frame and Screw Installer/Remover, press the bearing cup into position.
20. NOTE: The assembly requires centering to install the final bearing cup, due to spring pressure.
NOTE: Position the jaws of the Differential Bearing Remover and Step Plate into the driveshaft center yoke bearing cup bores.
With the Differential Bearing Remover and Step Plate in position, hand-tighten the puller to center the spider trunion in the bore.
21. Using the C-Frame and Screw Installer/Remover, install the final bearing cup.
-
Remove the C-Frame and Screw Installer/Remover, Differential Bearing Remover and Step Plate.
22. NOTE: If necessary, tap the yokes with a soft-faced hammer to seat the bearing cups.
Install the remaining snap rings.
23. Move the end yoke through the working angles to verify freedom of movement.