F 450 4WD Super Duty V8-6.4L DSL Turbo (2008)
5. Disconnect the front cooler tube assembly retainer from the frame rail and remove the front transmission fluid cooler tube assembly.
6. Remove the rear cooler tube assembly bracket nut.
^
To install, tighten to 11 Nm (8 ft. lbs.).
7. For gasoline engine vehicles, remove the starter harness bracket nut and position the harness and bracket aside.
^
To install, tighten to 25 Nm (18 ft. lbs.).
8. Disconnect the rear cooler tube assembly from the transmission and remove the assembly from the vehicle.
^
To install, tighten to 27 Nm (20 ft. lbs.).
9. To install, reverse the removal procedure.
^
Fill with clean automatic transmission fluid and check for leaks.