F 450 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
Starter Relay: Service and Repair
REMOVAL
WARNING: WHEN REPAIRING THE STARTER MOTOR OR PERFORMING OTHER UNDERHOOD WORK IN THE VICINITY OF
THE STARTER MOTOR, BE AWARE THAT THE HEAVY GAUGE BATTERY INPUT LEAD AT THE STARTER SOLENOID IS
ELECTRICALLY HOT AT ALL TIMES. THE PROTECTIVE CAP OR BOOT PROVIDED OVER THIS TERMINAL MUST BE
REPLACED AFTER MAINTENANCE IS COMPLETE. MAKE SURE TO DISCONNECT THE BATTERY GROUND CABLE BEFORE
WORKING ON THE STARTER MOTOR.
CAUTION: Do not disconnect the battery of the vehicle to be started. Disconnecting the battery could damage the vehicle electronic system.
1. Disconnect the battery ground cable.
2. Remove the relay cover.
3. Disconnect the starter motor solenoid relay switch wires and cables.
1
Remove the insulator.
2
Disconnect the starter motor relay trigger terminal connector.
3
Remove the starter motor solenoid relay switch terminal nuts.
4
Remove the engine control sensor wire and the generator wire.
5
Remove the battery cables.
4. Remove the starter motor solenoid relay switch.
1
Remove the starter motor solenoid relay switch bolts.
2
Remove the starter motor solenoid relay switch.
INSTALLATION
