F 450 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
6. Install new U-bolts and nuts. Tighten the nuts.
-
Note the U-bolt size and tighten to specification.
7. Lower the vehicle.
8. Recheck the caster.
Front
Lean Correction - Front, F-2-50, F-350, 4x4 and F-450, F-550
1. NOTE: Front side lean can be adjusted approximately 1.0 mm (3/8 inch) by installing shim D7TZ-5742-A on the low side. A vehicle that is low
at the front can be raised by installing shims at both sides.
Raise and support the vehicle.
2. Support the axle.
3. Remove and discard the four nuts and two U-bolts.
