F 550 2WD Super Duty V10-6.8L (2009)
Seats with heat or manual lumbar
10. Disconnect the backrest heater mat electrical connector attached to the cushion frame.
11. Release the rear and inboard side cushion trim cover J-clips to aid routing of the lumbar cable or backrest heater mat wire harness.
All seats
12. Remove the 2 recliner-to-cushion frame bolts.
-
To install, tighten to 50 Nm (37 lb-ft).
13. NOTICE: Do not damage the plastic pivot bushing when removing the backrest or the backrest may become loose.
NOTE: When installing, route the lumbar cable and heater mat wire behind the seat hinge (if equipped).
Remove the seat backrest.
-
Release the backrest pivot bushing.
-
Pull the backrest away from the seat hinge.
-
Remove the backrest.
-
Feed the lumbar cable and backrest heater mat wire through the seat cushion opening (if equipped).
14. To install, reverse the removal procedure.
Seat Recliner - Front, Bench Seat
Seat Recliner - Front, Bench Seat
Removal and Installation
