F 550 2WD Super Duty V10-6.8L (2009)
Seat Heater Switch: Service and Repair
Seat Control Switch
Seat Control Switch
Removal and Installation
1. Remove the front seat. For additional information, refer to Seat - Front, Bucket Seat See: Seats/Service and Repair/Front Seats/Seat - Front,
Bucket Seat.
2. Remove the manual lumbar handle.
1. Locate the slot in the manual lumbar handle.
2. Pry at 90 degrees of each side of the slot to release the tabs.
-
Remove the manual lumbar handle.
3. Release the clip and slide the recliner handle cover off.
4. Release the clips, slide forward and separate the cushion side shield insert.
5. Remove the seat control switch in the following sequence.
1. Remove the seat control switch knob.
2. Release the cushion side shield clips and separate the seat control switch.
3. Disconnect and remove the seat control switch.
6. To install, reverse the removal procedure.