F 550 2WD Super Duty V10-6.8L (2009)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Front
Wheel Speed Sensor - Front, Rear Wheel Drive (RWD)
Removal and Installation
1. Remove the wheel and tire.
2. Disconnect the wheel speed sensor electrical connector.
3. Remove the wheel speed sensor harness bolts and detach the harness from the radius arm.
-
To install, tighten to 15 Nm (133 lb-in).
4. Remove the wheel speed sensor bolt and the sensor.
-
To install, tighten to 25 Nm (18 lb-ft).
5. NOTICE: Make sure the wheel speed sensor harness is correctly routed to prevent the brake disc from damaging the harness.
To install, reverse the removal procedure.