F 550 2WD Super Duty V10-6.8L (2009)
Engine Oil Dip Stick - Dip Stick Tube: Service and Repair
Oil Level Indicator and Tube
Oil Level Indicator and Tube
Removal and Installation
1. Remove the front oil level indicator and tube bolt.
-
To install, tighten to 25 Nm (18 lb-ft).
2. Remove the rear oil level indicator and tube bolt.
-
To install, tighten to 10 Nm (89 lb-in).
3. Remove the oil level indicator and tube from the cylinder block.
-
Discard the O-ring seal.
4. NOTE: Lubricate the new oil level indicator tube O-ring seal with clean engine oil prior to installation.
To install, reverse the removal procedure.