F 550 2WD Super Duty V10-6.8L (2009)
Oil Cooler: Service and Repair
Oil Cooler
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Drain the engine cooling system.
3. Remove and discard the oil filter.
-
To install, tighten to 16 Nm (142 lb-in).
4. Disconnect the oil cooler coolant hoses and position aside.
5. NOTICE: If metal foreign material is present in the oil cooler, mechanical concerns exist. To diagnose mechanical concerns, refer to
Engine. If the mechanical concern is not diagnosed and repaired, engine failure may occur. See: Testing and Inspection
Remove the threaded insert and the engine oil cooler.
-
Inspect the oil cooler.
-
To install, tighten to 58 Nm (43 lb-ft).
6. To install, reverse the removal procedure.
