F 550 2WD Super Duty V10-6.8L (2009)
6. Install the 2 upper TB spacer bolts in 2 stages:
-
Stage 1: Tighten to 7 Nm (62 lb-in).
-
Stage 2: Tighten an additional 90 degrees.
7. Install the 4 lower TB spacer bolts in 2 stages:
-
Stage 1: Tighten to 10 Nm (89 lb-in).
-
Stage 2: Tighten an additional 90 degrees.
8. Install a new gasket and the TB. Tighten the 4 bolts in 2 stages:
-
Stage 1: Tighten to 9 Nm (80 lb-in).
-
Stage 2: Tighten an additional 90 degrees.
9. Position the IMRC actuator and install the 3 bolts.
-
Tighten to 10 Nm (89 lb-in).
10. Install the IMRC rod C-clip.
