F 550 2WD Super Duty V10-6.8L (2009)
Water Pump: Service and Repair
Coolant Pump - Fuel Charging and Controls
Coolant Pump
Removal and Installation
1. Drain the fuel and turbocharger cooling system. For additional information, refer to Fuel and Turbocharger Cooling System Draining, Filling and
Bleeding See: Powertrain Management/Fuel Delivery and Air Induction/Service and Repair.
2. Remove the LH fender splash shield.
3. Disconnect the radiator-to-coolant pump hose at the coolant pump.
4. Disconnect the coolant pump-to-fuel cooler hose at the coolant pump.
5. Remove the 2 bolts and detach the coolant pump from the cooling module.
-
To install, tighten to 3 Nm (27 lb-in).
6. Disconnect the coolant pump electrical connector and remove the coolant pump.
7. To install, reverse the removal procedure.
-
Fill and bleed the fuel and turbocharger cooling system. For additional information, refer to Fuel and Turbocharger Cooling System Draining,
Filling and Bleeding See: Powertrain Management/Fuel Delivery and Air Induction/Service and Repair.
