ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2996 > < Initial Inspection and Diagnostic Overview|Page 2994
Page 17
background image

-

Are the voltages greater than 10 volts?

Yes

GO to G2.

No

VERIFY the Battery Junction Box (BJB) fuses 37 (10A) and 72 (15A) are OK. If OK, REPAIR the circuit in question. If not OK, REFER to the Wiring
Diagrams to identify the possible causes of the circuit short. CLEAR the DTCs. REPEAT the network test with the scan tool.

-------------------------------------------------
G2 CHECK THE TCM GROUND CIRCUIT FOR AN OPEN

-

Ignition OFF.

-

Disconnect: Negative Battery Cable.

-

Measure the resistance between the TCM harness side and ground as follows:

-

Are the resistances less than 5 ohms?

Yes

GO to G3.

No

REPAIR the circuit. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool.

-------------------------------------------------
G3 CHECK THE HS-CAN CIRCUITS BETWEEN THE TCM AND THE
DLC FOR AN OPEN

-

Measure the resistance between the TCM C1750-47, circuit VDB04 (WH/BU), harness side and the Data Link Connector (DLC) C251-6, circuit
VDB04 (WH/BU), harness side.

Initial Inspection and Diagnostic Overview|Page 2996 > < Initial Inspection and Diagnostic Overview|Page 2994