ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3039 > < Initial Inspection and Diagnostic Overview|Page 3037
Page 60
background image

-

Are the resistances greater than 5,000 ohms?

Yes

CONNECT all modules. CONNECT the negative battery cable. GO to T33.

No

GO to T24.

-------------------------------------------------
T24 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE RCM DISCONNECTED

-

Disconnect: RCM C310b.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.

-

Are the resistances greater than 5,000 ohms?

Yes

CONNECT all modules. CONNECT the negative battery cable. GO to T34.

No

If the vehicle is equipped with an APIM, GO to T25.

If the vehicle is not equipped with an APIM, GO to T26.

-------------------------------------------------
T25 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE APIM DISCONNECTED

-

Disconnect: APIM C3342.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.

-

Are the resistances greater than 5,000 ohms?

Yes

CONNECT all modules. CONNECT the negative battery cable. GO to T35.

No

GO to T26.

-------------------------------------------------
T26 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE IC DISCONNECTED

Initial Inspection and Diagnostic Overview|Page 3039 > < Initial Inspection and Diagnostic Overview|Page 3037