F 550 2WD Super Duty V10-6.8L (2009)
1. NOTE: It is necessary to record the current Accessory Protocol Interface Module (APIM) software and hardware level when a new APIM is being
installed to make sure that the new component is the same version as the component being replaced.
Retrieve and record the current APIM software and hardware level. For additional information, refer to Accessory Protocol Interface Module
(APIM) Software Level Check See: Procedures/Accessory Protocol Interface Module (APIM) Software Level Check.
2. Lower the glove compartment completely.
3. Disconnect the APIM electrical connector and the Universal Serial Bus (USB) cable electrical connector.
4. Remove the RH instrument panel side trim panel.
5. Remove the 2 screws and the APIM.
-
Remove the APIM through the glove compartment opening.
6. To install, reverse the removal procedure.
-
If a new APIM is being installed, program the APIM to the correct software level.
Universal Serial Bus (USB) Cable and Port
Universal Serial Bus (USB) Cable and Port
Removal and Installation
1. Remove the instrument panel.
2. Using a suitable flat-bladed tool, remove the audio input jack bezel by prying it straight rearward.