F 550 2WD Super Duty V10-6.8L (2009)
4. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable assembly between the manual control
lever and the selector lever cable bracket.
NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever
cable into the bracket and listen for the cable to click in place. Pull back on the sector lever cable to make sure that it is locked into the bracket.
Connect the selector lever cable onto the manual control lever.
5. Push the rubber grommet and selector lever cable up through the floor pan.
6. Connect the cable pushpin onto the stud on the dash panel.
7. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable assembly between the selector lever arm
ball stud and the steering column bracket.
NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever
cable into the bracket and listen for the cable to click in place. Pull back on the selector lever cable to make sure that it is locked into the bracket.
Connect the selector lever cable onto the steering column.
1. Connect the selector lever cable retainer.
2. Connect the selector lever cable onto the steering column bracket.
3. Connect the selector lever cable onto the selector lever arm ball stud.
-
Listen for the audible click.
-
Pull back on the selector lever cable to make sure that it is correctly installed.
8. Install the steering column lower shroud.
1. Install the screws and the lower shroud.
