F 550 2WD Super Duty V10-6.8L (2009)
4. Position the cables and install the starter solenoid terminal eyelet nuts and ground cable stud bolt.
-
Tighten the ground cable stud bolt to 10 Nm (89 lb-in).
-
Tighten the starter solenoid B-terminal nut to 12 Nm (106 lb-in).
-
Tighten the starter solenoid S-terminal nut to 5 Nm (44 lb-in).
5. Install the terminal cover.
6. Install the exhaust system Y-pipe.
7. Connect the battery.
8. Position the starter harness bracket onto the stud and install the nut.
-
Tighten to 25 Nm (18 lb-ft).
9. Position the transmission fluid cooler tube assembly bracket onto the stud and install the nut.
-
Tighten to 11 Nm (97 lb-in).
10. Install the front transmission fluid cooler tube assembly and connect the front transmission fluid cooler tube assembly retainer to the frame rail.
11. Connect the transmission fluid cooler tube assemblies.