F 550 2WD Super Duty V10-6.8L (2009)
Back Window Regulator: Service and Repair
Window Regulator and Motor - Rear
Window Regulator and Motor - Rear
Removal and Installation
Regular and Crew Cab vehicles
1. Remove the rear trim panel.
SuperCab vehicles
2. Remove the rear seat backrest.
3. Remove the B-pillar trim panels.
All vehicles
4. Position the sliding glass to the halfway OPEN position.
5. Remove the bumpers from the sliding window bracket.
6. NOTICE: Slowly release the spring tension after the cable swag is removed from the sliding glass channel bracket. If the spring tension is
suddenly released, the cables can unwind from the drum. If the cables unwind from the drum, a new regulator and motor assembly will
have to be installed.
NOTE: RH shown, LH similar.
Remove the cable swags from the sliding window glass channel bracket.
-
Carefully squeeze the regulator and motor assembly spring to create slack in the cable.
-
Remove the cable swag from the sliding window glass channel bracket.
7. Pull the LH and RH cable ends out of the sliding window trough.
8. Disconnect the power sliding window cable retainer clips.