F 550 2WD Super Duty V10-6.8L VIN S (2000)
5. Install the brackets over the studs and loosely install the nuts.
6. Connect the two auxiliary evaporator inlet lines.
CAUTION: Use a wrench on each side of the fitting to prevent damage to the A/C fitting.
NOTE: Lubricate the O-ring seals with PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN-12-C) or
equivalent meeting Ford specification WSH-M1C231-B.
7. Tighten the five bracket nuts.
CAUTION: Overtightening of the nut will cause the stud to break away from the floor pan.
8. Reattach the ABS wiring harness and position the fender splash shield in the wheel well.
