F 550 2WD Super Duty V10-6.8L VIN S (2000)
3. Twist off the cap from the ignition switch lock cylinder.
4. Remove the ignition switch lock cylinder.
-
Use a 1/8-inch diameter drill bit to drill out the lock cylinder retaining pin.
-
Use a 3/8-inch diameter drill to drill down the middle of the ignition lock key slot until the ignition switch lock cylinder breaks loose.
-
Remove and discard the ignition switch lock cylinder and drill shavings from the steering column.
5. CAUTION: Carefully note the position of the steering column lock gear, bearing and retainer prior to removal.
Remove the bearing retainer.
