F 550 2WD Super Duty V10-6.8L VIN S (2000)
30. Tighten dry side cover bolts to specification.
31. NOTE: Remove the tape from the sector shaft and pack the end of the housing trunnion area at the sector shaft with Mobil Temp 1 or 2, High
Temperature Front Axle and Wheel Bearing Grease E8TZ-19590-A or equivalent meeting Ford specification ESA-M1C198-A.
Apply the grease to a new trunnion dirt seal and assemble it over the sector shaft and into the trunnion bore.
32. NOTE: Pack the end of the valve housing bore around the input shaft with High Temperature Front Axle and Wheel Bearing Grease
E8TZ-19590-A or equivalent meeting Ford specification ESA-M1C198-A.
Apply more of the grease to the inside of a new dirt and water seal and install it over the input shaft and seat it in the groove behind the serrations
and against the valve housing.
33. Adjust the steering gear meshload.
Steering Gear Adjusting Screw and Retainer - Motorhome
Steering Gear Adjusting Screw and Retainer - Motorhome
Disassembly
