F 550 2WD Super Duty V10-6.8L VIN S (2000)
12. Remove the nuts and the clutch pedal and support bracket.
13. To install, reverse the removal procedure noting the following:
^
Seat the clutch master cylinder rubber seal to the bulkhead after locking the clutch master cylinder in the clutch pedal and support bracket.
^
Route the clutch master cylinder-to-slave cylinder hydraulic tube under the brake booster after installing the clutch master cylinder.
14. CAUTION: When installed correctly, the flat side of the clutch pedal position switch must face the tab protruding from the clutch master cylinder
, and the switch wiring connector must be in the 12 o'clock position. Incorrect installation will damage the clutch pedal position switch and cause
insufficient dutch pedal travel.
Correctly position the clutch pedal position switch when installing it on the clutch master cylinder push rod.
