F 550 2WD Super Duty V10-6.8L VIN S (2000)
5. Install the hex nut.
^
Using a suitable torque multiplier, tighten the hex nut.
Measuring pinion beating preload torque
6. Measure the torque to rotate.
^
Take torque measurements every fourth revolution.
^
Proceed to Pinion bearing preload adjustment in this procedure if the bearing preload torque is not within the specifications. Proceed to Final
assembly in this procedure if the bearing preload torque is within the specifications.
Pinion bearing preload adjustment
7. Note: Also refer to the illustration.
