F 550 2WD Super Duty V10-6.8L VIN S (2000)
1. WARNING: Replace with new bolts after the Third removal.
NOTE: Prior to the third removal, clean the bolt threads and apply Loctite(R) 242 or equivalent. Install driveshaft to transmission flange bolts.
For vehicles equipped with a manual transmission, align the index marks and connect the front driveshaft to the transmission.
Hand tighten only; do not tighten at this time.
2. For vehicles equipped with an automatic transmission, align the index marks and slide the driveshaft slip yoke onto the output shaft.
3. Position the center support bearing and install the bolts.
-
Hand tighten only; do not tighten at this time.
