F 550 2WD Super Duty V10-6.8L VIN V (2005)
8. Install the flexplate inspection cover and the 2 bolts.
^
Tighten to 34 Nm (25 ft. lbs.).
9. Lower the transmission.
10. Align the engine mount studs and lower the engine.
^
Remove the special tool.
11. CAUTION: Only use hand tools when installing the RH engine mount nut or damage to the engine mount can occur.
NOTE: Align the engine-to-transmission dowels before installing the engine mount bolt.
NOTE: RH shown, LH similar. Install the 6 engine mount nuts.
^
Tighten to 175 Nm (129 ft. lbs.).
12. CAUTION: Only use hand tools when removing the transmission mount-to-crossmember nuts or damage to the transmission mount can occur.
