F 550 2WD Super Duty V10-6.8L VIN V (2005)
Apply a 4.06-mm (0.16-inch) bead of silicone gasket and sealant around the crankshaft rear seal retainer plate sealing surface.
3. Install the crankshaft rear seal retainer plate and the 6 bolts in the sequence shown.
^
Tighten to 10 Nm (89 inch lbs.).
4. Install the 2 crankshaft rear seal retainer plate-to-oil pan bolts.
^
Tighten to 20 Nm (15 ft. lbs.).
5. NOTE: Lubricate the inner lip of the crankshaft rear seal with clean engine oil.
Using the special tools, install the crankshaft rear seal.
6. Using the special tools, install the crankshaft rear oil slinger.
7. Install the flexplate or flywheel.
