F 550 2WD Super Duty V10-6.8L VIN V (2005)
3. Tighten the engine front cover fasteners in sequence in 2 stages.
Stage 1: Tighten fasteners 1 through 15 to 25 Nm (18 ft. lbs.).
Stage 2: Tighten fasteners 6 and 7 to 48 Nm (35 ft. lbs.).
4. Loosely install the bolts, then tighten the bolts in 2 stages, in the sequence shown.
^
Stage 1: Tighten to 20 Nm (15 ft. lbs.).
^
Stage 2: Tighten an additional 60 degrees.
5. Using a new O-ring seal, install the crankshaft position (CKP) sensor and the bolt.
^
Lubricate the new O-ring seal with clean engine oil prior to installation.
^
Tighten to 10 Nm (89 inch lbs.).
6. Connect the CKP sensor electrical connector.