F 550 2WD Super Duty V10-6.8L VIN V (2005)
3. NOTE: There is a metal gasket between the exhaust inlet pipe and the exhaust gas recirculation (EGR) cooler.
Remove the exhaust inlet pipe-to-EGR cooler clamp.
4. Remove the LH exhaust inlet pipe-to exhaust manifold nuts.
5. Remove the RH exhaust inlet pipe-to exhaust manifold nuts.
6. Carefully remove the exhaust inlet pipe assembly from the vehicle.
Installation
1. NOTE: When installing the exhaust inlet pipe into the vehicle, do not bend or twist the flex bellows.
Install the exhaust inlet pipe. Position the pipe to the exhaust manifolds.
2. Apply anti-seize lubricant to the exhaust inlet pipe bolts, then install the bolts and nuts. Do not tighten the nuts at this time.
