F 550 2WD Super Duty V10-6.8L VIN V (2005)
Engine Control Module: Service and Repair
Removal and Installation
POWERTRAIN CONTROL MODULE (PCM)
Removal and Installation
1. Disconnect the battery ground cable.
2. NOTE: Refer to Computers and Control Systems for correct worldwide diagnostic system (WDS) hook-up procedure.
Connect the diagnostic tool to the vehicle. Allow the diagnostic tool to identify the vehicle and obtain configuration data.
-
All programmable module information will automatically be retrieved by the WDS.
3. Disconnect the PCM electrical connectors.
4. Remove the 2 bolts and the PCM.
-
To install, tighten to 7 Nm (62 lb-in).
5. To install, reverse the removal procedure.
