F 550 2WD Super Duty V10-6.8L VIN V (2005)
Turn Signal Switch: Service and Repair
Multifunction Switch
Removal and Installation
1. Disconnect the battery.
2. Remove the ignition switch lock cylinder.
1
Insert the ignition key into the lock cylinder and turn the ignition switch to the RUN position.
2
Push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.
3. If equipped, twist the tilt wheel handle and remove it.
4. Remove the steering column shrouds.
1
Remove the screws.
2
Separate and remove the upper and lower steering column shrouds.
