F 550 2WD Super Duty V10-6.8L VIN V (2005)
Oil Temperature Sensor For ECM: Service and Repair
OIL TEMPERATURE SENSOR
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Drain the engine oil.
4. Disconnect the EOT sensor electrical connector.
5. Remove the EOT sensor. Discard the O-ring seal.
-
To install, tighten to 15 Nm (11 lb-ft).
-
Install a new O-ring seal. Lubricate the new O-ring seal with clean engine oil prior to installation.
6. To install, reverse the removal procedure.
