F 550 2WD Super Duty V10-6.8L VIN V (2005)
9. Lower the transmission enough to gain access to the turbine shaft speed (TSS) sensor and intermediate shaft speed sensor.
10. Disconnect the intermediate shaft and turbine shaft combination speed sensor electrical connector.
NOTE: Prior to removing the speed sensor, make sure that the area around the sensor is free of foreign material to prevent contamination of the
transmission.
11. Remove the intermediate shaft and turbine shaft combination speed sensor.
1
Remove the bolt.
2
Remove the intermediate shaft and turbine shaft combination speed sensor.
INSTALLATION
1. Install the intermediate shaft and turbine shaft combination speed sensor.
1
Lubricate the O-ring and install the intermediate shaft and turbine shaft combination speed sensor.
2
Install the bolt.
2. Connect the intermediate shaft and turbine shaft combination speed sensor electrical connector.
3. Raise transmission into position.
4. Position the crossmember to the transmission insulator and retainer, and loosely install the nut.
5. Install the LH crossmember bolts.
