F 550 2WD Super Duty V10-6.8L VIN V (2005)
Clutch Master Cylinder: Service and Repair
Clutch Master Cylinder and Reservoir
Material
Removal and Installation
NOTE: Remove the entire clutch hydraulic system from the vehicle as an assembly when installing a new clutch master cylinder assembly. The clutch
master cylinder is only serviced in the assembly.
1. Disconnect the clutch hydraulic tube from the dash clip.
2. With the vehicle in NEUTRAL, position it on a hoist.
3. Unlock and remove the clutch slave cylinder from the transmission.
^
Compress and twist the clutch slave cylinder counterclockwise to unlock it from the transmission.
4. Disconnect the clutch hydraulic tube from the floor pan clip. Position the clutch slave cylinder and hydraulic tube forward below the left engine
bank. This will make it easier to unlock the clutch master cylinder from the clutch pedal and support bracket by reducing tension on the hydraulic
tube.
5. Lower the vehicle.
6. WARNING: The clutch pedal is under spring tension.
