F 550 2WD Super Duty V10-6.8L VIN Z Bi-Fuel (2001)
5. Remove the EVAP canister.
6. Remove the canister vent solenoid from the EVAP canister, if equipped.
7. Remove the EVAP canister elbow.
INSTALLATION
1. To install, reverse the removal procedure.
^
Leak test the EVAP system. See: Testing and Inspection/Component Tests and General Diagnostics/Evaporative Emission System Leak Test
^
Carry out the evaporative emission repair verification drive cycle. See: Testing and Inspection/Component Tests and General
Diagnostics/Evaporative Emission Repair Verification Drive Cycle
NOTE: Lubricate all evaporative emission O-ring seals with MERPOL(R) O-ring Seal Lubricant or equivalent meeting Ford specification
ESE-M99B144-B.
