F 550 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
6. Using the special tool, remove and discard the crankshaft rear seal.
7. NOTE: Production engines will not have a wear sleeve.
If equipped with a crankshaft wear sleeve, use the special tool to remove and discard the crankshaft rear wear sleeve.
8. Clean and inspect the crankshaft sealing surface.
Installation
All vehicles
1. NOTE: The crankshaft rear seal and wear sleeve are installed as an assembly.
NOTE: Lubricate the outer diameter of the rubber seal with a solution of dish soap and water (approximately 50/50 mix) prior to assembly. Do
not use any other type of lubricant.
Apply a bead of Threadlock 262 around the circumference of the outer rear edge of the secondary crankshaft flange.
2. Using the special tool, install a new crankshaft rear seal.